K Series Rocker Arm Holders

No more zip ties! 
These holders are designed to keep the three lifters connected together, ensuring no pins or springs gong flying as you remove the rocker arm assembly. Specifically designed for 3 Lobe Honda K Series engines. This includes K20a, K20a2, K20z1, K20z3, K24a, K24a2, K24z7 and more. Easily slide the holders on, remove the rocker arm assembly. When it comes time to reinstall it’s as simple as sliding the holders right back off. No rubber bands, no zip ties to cut and most importantly there’s no need to move, or even touch the lifters to install the holders. 

On cylinders 1&2 the rocker arms are slightly too close to the cam holders and do not provide enough space for the normal C clip style holder to fit. I have designed a slightly different style for cylinders 1&2. 

These holders come as a set of 13 with

8 C clip style holders

5 holders designed for CYL 1&2 

 Updated August 2025

The new updated Rocker Arm Holders are stronger, more material was added to the C-Clip style and CYL 1&2 style to strength after repeated use. 
CYL 1&2 Style received extra support in the jaw area as well as shortened lower fingers. This makes installing CYL 1&2 holders much easier when compared to V1. 
C-Clip style now has small relief cuts on the bottom side to make installation easier around the valve spring retainer. 
Both styles also received new printing techniques to ensure a nice clean uniform look across all Rocker Arm Holders. Post Processing now includes a mild heat treatment, thorough inspection of each holder, fit check of each holder and strength/elasticity check of each holder.  
As winter approaches we would like to remind everyone that these holders are plastic and have a certain working temperature range. Please ensure the holders are at room temperature or above 56 degrees Fahrenheit prior use. Using this tool under the desired temperature may result in damage to the tool. It is okay to store the tool in cool temperatures, avoid freezing temperatures, however it is recommended to warm the holders up either just by simply setting them inside a room temperature area or leaving them in a pocket for a few minutes.